Right, so I cannot draw for squat. However, I'm decent at other things.
The scooter below is made up of 21 separate pieces, all of which can be printed on a MakerBot Thing-O-Matic which the printable area is:
'105mm x 120mm and about 130mm tall'
(from
[You must be registered and logged in to see this link.]The orientation of each piece is critical for its sturdiness.
If I were to go about printing this:
1. I would need a 3D printer
2. I would have to pay someone a lot of money.
3. I would take over 40 hrs of straight build time (each wheel is over 3hrs)
The reveal!!!!
The first does not have edges, the latter one does.
[You must be registered and logged in to see this image.]I will get a screenie of the stress test eventually. Once I figure out why it's breaking (the program, not my scooter) on me.